Ryobi TSS100L1 - Manual (Page 20)

20 — English
MITER
TABLE
COMBINATION
SQUARE
BLADE
MITER
FENCE
ASSEMBLY
SCALE
INDICATOR
Fig. 22
INDICATOR
SCREW
BEVEL
SCALE
SQUARING THE BLADE TO THE MITER TABLE
See Figures 22 - 25.

Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock handle approximately one-half turn.
 Rotate the miter table until the pointer on the control arm
is positioned at 0°. Securely tighten the miter lock handle.
 Loosen the bevel lock lever and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock lever.
 Place a combination square against the miter table and
the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be
parallel as shown in figure 23.
 If the top or bottom of the saw blade angles away from
the square as shown in figures 24 and 25, adjustments
are needed.
 Loosen the lock nut securing positive stop adjustment
screw. Also loosen bevel lock lever.
 Adjust positive stop adjustment screw to bring saw
blade into alignment with the square. See Positive Stop
Adjustment in the Adjustment section.
 Retighten bevel lock lever. Next, retighten lock nut
securing the positive stop adjustment screw. Recheck
blade-to-table alignment.
NOTE: The above procedure can be used to check blade
squareness of the saw blade to the miter table at both 0°
and 45° angles.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicator
screws and reset them to zero.
Fig. 23
CORRECT VIEW OF BLADE
SQUARE WITH MITER TABLE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
ADJUSTMENTS ARE REQUIRED
Fig. 24
Fig. 25
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
ADJUSTMENTS ARE REQUIRED
MITER
TABLE
COMBINATION
SQUARE
BLADE
MITER
FENCE
POSITIVE STOP
ADJUSTMENT
SCREW
LOCK
NUT(S)
MITER
TABLE
MITER
LOCK HANDLE
COMBINATION
SQUARE
BLADE
MITER
FENCE