Zylight Z90 LED Light - Manual (Page 6)

6
Using ZyLink
™
(patent pending)
Overview
Every Z90 can be wirelessly linked to other Zylights (Z50 or Z90), creating a
group of lights that operate in concert as if they were one larger light. The group
can contain as many Zylights as you need. Adjusting the controls on one Zylight
in the group will change all of the other lights in the group.
You can have Zylights operating independently at the same time you have
linked Zylights. Any independent Zylight can be added to an existing group, and
any linked Zylight can be removed from a group.
ZyLink
™
settings are saved even if power is removed from the Z90. This allows
you to remove power from your lights during down-time, and resume lighting
later without having to re-group the lights.
ZyLink ™ QuickStart
1. Plug in at least two Z90s.
2. On one Z90, push in and hold the bottom thumbwheel until the
ZYLINK
indicator glows.
3. Select the desired ZyLink
™
channel by pushing and releasing bottom
thumbwheel until the correct channel is displayed.
4. Repeat steps 2 & 3 with other Z90s you wish to link together.
5. That’s it! When the controls are adjusted on one of the Z90s on the same
channel, all of the lights on that channel will change.
Enabling & Disabling ZyLink™
To turn ZyLink
™
on or off, push in and hold the bottom thumbwheel for ~1
second. The
ZYLINK
indicator will glow whenever ZyLink
™
is enabled.
Changing the ZyLink ™ Channel
The Z90 has ten available ZyLink
™
channels. With ZyLink
™
enabled, change
channels by pushing and releasing the bottom thumbwheel until the desired
channel is displayed.
ZyLink ™ between the Z90 and Z50
The Z90’s ZyLink
™
channel 1 is compatible with Z50 lights. If you wish to
control a Z50 with a Z90 (or vice-versa) be sure your Z90 is set to channel 1.
NOTE:
Since the Z50 does not have a
GEL
mode, the Z90 must be in either
WHITE or COLOR modes to use ZyLink
™
with a Z50.
— Note: Removing power from any linked Z50 will also un-link it. Do not
remove power from any Z50 or group of Z50s you wish to remain linked.
You will then have to re-enable ZyLink
™ on the Z50(s) that had their
power removed. See the Z50 User Guide for more information.