Zylight Z90 LED Light - Manual (Page 7)

7
Using the Accessory Adapter
Overview
The Z90’s Accessory Adapter allows you to mount most standard lighting
accessories with a 3-inch [76mm] mounting flange, such as a soft box or
barndoors. Accessories with a mounting flange up to 0.075” [1.9mm] thick can
be mounted.
Mounting the Accessory Adapter
The Accessory adapter slides onto the Z90 from either side of the light.
1. Position the Accessory Adapter parallel with the front of the
Z90 with the locking tab resting on the front window. Position
the two spring clips so that they are touching the rounded
corners on the short side of the heatsink.
2. Slide the Adapter onto the light, expanding the two spring clips
as the heatsink rails slide between the heatsink fins.
Mounting the Accessory
To mount the accessory, slide its flange over the locking tab and under the two
accessory flanges.
Removing the Accessory
To remove the accessory, gently depress the locking tab and slide the
accessory out of the flanges.
Removing the Accessory Adapter
To remove the Accessory Adapter, slide the Adapter off of the light in the
opposite direction as it was installed.
SPRING CLIPS
LOCKING TAB
HEATSINK
RAILS
ACCESSORY
FLANGES