F8 fresnel operations – Zylight F8 Fresnel User Manual

Page 10

Advertising
background image

F8 Fresnel

Operations

Power Supply: The Zylight F8 Fresnel contains an automatic voltage
switch, which will auto sense the voltage when it is plugged into the
power source. With this switch there is no need to worry about the
correct power voltage; this unit can be plugged into any outlet rated for
100-240v AC. Also, be sure to only use the included power cable
supplied with the unit.

Power is supplied through a standard 4-pin XLR connector using either
the included Worldwide AC Adapter (P/N 13-17005) or a suitable 14.4V
battery. Please observe correct polarity. Batteries that indicate a full
charge when idle may quickly drop in capacity when under load. For
optimal operation please fully charge batteries before use and be sure
they are rated to provide up to 100W of continuous power, with at least
8.3 amps.

Focus Knob

Yoke/Handle

Mount

Dimmer

DMX Breakout Jack

Yoke/Handle

Mount

Power Input

MODE Knob to set

DMX Address & ZyLink Channel

Page 9

Advertising