Cabletron Systems SMARTSWITCH ROUTER 9032578-05 - Manual (Page 351)

SmartSwitch Router User Reference Manual 325
Chapter 23: RMON Configuration Guide
Creating RMON CLI Filters
To create RMON CLI filters, use the following CLI command in Configure mode:
Using RMON CLI Filters
To see and use RMON CLI filters, use the following CLI command in User or Enable
mode:
Troubleshooting RMON
If you are not seeing the information you expected with an rmon show command, or if the
network management station is not collecting the desired statistics, first check that the
port is up. Then, use the rmon show status command to check the RMON configuration
on the SSR.
Creates an RMON CLI filter. rmon set cli-filter <filter-id> <parameter>
Displays RMON CLI filters. rmon show cli-filters
Applies a CLI filter on current
Telnet or Console session. rmon apply cli-filters <filter-id>
Clears the currently-selected
CLI filter. rmon clear cli-filter