Axesstel MV400 - Manual (Page 17)

16
1.2 Make sure you have the following items at the computer that is going to be
the main connection with the Modem. DO NOT CONNECT THE MODEM
AT THIS TIME.
• The Installation Software CD with User Manual
• The Modem
• The Modem’s Power Supply
• RJ45 Ethernet Networking Cable
1.3 Turn off any firewall or Internet-connection-sharing software on your
computer.
1.4 Insert the installation software CD into your CD-ROM drive. The Installation
screen will automatically appear on your screen within 15 seconds. If it does
not, select your CD-ROM drive from “My Computer” and double-click on the
file named “AxessManager_0992_Setup.exe” on the CD-ROM.
IMPORTANT: If you have MV400-series or MV400i-series, continue to the next
steps below. If you have MV400R-series, skip the rest of this chapter and go to
AxessManager Operation Guide section.
Step 2
│
Set up the Hardware
2.1. Make sure your Modem is not connected to any power source and all the
LED are OFF.
2.2 Locate the CAT-5 Ethernet cable that is included with your Modem. Plug
one end of this cable into ANY one of the Ethernet ports on your Modem.
Plug the other end of the cable into the networking port on your computer.
2.3 Locate the power supply that is included with your Modem. Plug the power
supply’s small connector into the power port on the Modem. Plug the power
supply into an empty power outlet.
2.4 Switch on the Modem. Look at the Power LED on top of the Modem and
make sure the lights are ON.
2.5 Wait for a few seconds for the Modem to search for service network. Once
the Modem finds a suitable network, observe the Signal LED turns to Red,
Orange or Green depending on the strength of acquired signal. Refer to the
Signal Strength LED description for more details.