Curtis TC924 - Manual (Page 12)

Placing Calls
1. Press the Talk button, the Call Timer
starts to count.
2. Wait until you hear a dial tone and then
dial the phone number.
3. When you have finished your call, press
the Talk button again or place the
HANDSET on the BASE UNIT.
OR
1. Dial the phone number.
2. Press the Talk button. The number
displayed will be dialed.
3. When you have finished with your call,
press the Talk button again or place
the HANDSET on the BASE UNIT.
Redial Feature
1 . If you get a busy tone, press the Talk
button or place the HANDSET on the
BASE UNIT to hang up.
2. Later, press the Talk button again.
3. Listen for a dial tone.
4. Press the Re/Pa/Save button. This
will automatically redial the last
telephone number you called.
5. When you have finished with your call,
press the Talk button again or place
the HANDSET on the BASE UNIT.
NOTE:
If you are too far away from the BASE UNIT, the HANDSET emits “beep” sounds
to warn you that the background noise level is too high for proper communication
between the HANDSET and the BASE UNIT. When you hear this sound, you
should move closer to the BASE UNIT to reduce the noise level. Otherwise, the
call will automatically cut off.
Cordless Telephone Operation
11
AM