OFNA Racing DM-1 RTR - Manual (Page 24)

Step 1
ASSEMBLY OF THE WHEELS ONTO THE FRONT KNUCKLE AND REAR HUB 54
Step 3
Step 1
Step 2
ASSEMBLY OF THE BODY AND PAINTING
19
55
Step 5
Step 4
Spray Paint
Cut out the body as shown.
Completely Finished.
Use a neutral detergent to
remove any dirt and oil. Mask the windows from
the inside with masking tape.
Before cutting and making holes in the body, put the unpainted body
on the chassis to confirm the mounting position and location for holes.
Use body reamer or drill to make two 8mm holes in the front and two 8mm holes in the rear.
Step 6 Paint the body with
polycarbonate spray paints.
Body Reamer
(Not included.)
.....x4
40550
Wheel Nut
Tire and Wheel
assembly.
40550
Wheel Nut
40550
Wheel Nut
Cut Out
*Make two 8mm holes
for the side body posts.
*Make a hole for
exhaust gas deflector.
Assembly of the right and left hand side
are the same.
*Notice the direction of
the tire pattern.
*Notice the direction of
the tire pattern.