OFNA Racing DM-1 Spec RTR - Manual (Page 25)

ASSEMBLY OF THE ONTO FRONT KNUCKLE AND REAR HUB 53
ASSEMBLY OF THE BOOY AND PAINTNG. 52
Spray Paint
Paint the body with
polycarbonate spray paints.
Before cutting and making holes on the body,
put the unpainted body on the chassis
to confirm the mounting position and
location for holes and cutouts. Mask the windows from
the inside with masking tape.
Making two holes on the front and
two holes on the rear for body posts.
Step 1 Step 2
9mm
Nylon Screw
Do Not
Over Tighten
Take off the doubleside
paper before assembly.
Side Plate
Side Plate
Doubleside
Tape
Doubleside
Tape
9mm
Nylon Nut
Cut Out
Cut Out
Body Reamer
(Not included.)
31141
Body(Stock) Use a neutral detergent to
remove any dirt and oil. Cut out the body as shown.
19