OFNA Racing DM-1e Spec - Manual (Page 25)

52
53
54 MAKING HOLES AND CUTTING ON THE WING
MAKING HOLES AND CUTTING ON THE BODY SHELL
MAKING HOLES AND CUTTING ON THE WING
Before making holes on the body,
put the unpainted body on the chassis
to confirm the mounting position and
location for holes.
Step 1 Step 2
Make 9mm holes on the body shell as shown.
Make 4mm holes
Make 7mm holes
Body Reamer (not included)
Make a 7mm hole
Make a 7mm hole
Make 3mm holes
Make 3mm hole
Make 3mm holes
Make 3mm hole
Wing Side Plate(L)
Wing Side Plate(R)
Step 1 Step 2
The position and the wing is the same.
Hole Position
Hole Position
Hole Position