OFNA Racing Late Model Dirt Oval - Manual (Page 21)

17
49 ASSEMBLY OF THE TIRES AND WHEELS
T
INS
TA
N G
LU
E
*Pull back the tire bead slightly and spot glue in four spots as
shown. When dry, glue the rest of the wheel between the spots.
Repeat the procedure on the other side of the wheel until fully
glued.
51 ASSEMBLY OF THE BODY
50 ASSEMBLY OF THE WHEELS ONTO THE FRONT KNUCKLE AND REAR HUB
40550
Assembly for both right and left side.
Tire and Wheel assembly.
40550
Wheel Nut
.....x4
40550
40550
40550
Step 1 Step 2 Cut out the body as shown. Before cutting and making holes in the body, put the unpainted body on the chassis to
confirm the mounting position and location for holes.
Use body reamer or drill to make two 8mm holes in the front and two 8mm holes in the rear.
Body Reamer
(Not included.)
Cut Out
86026
86059
86050
86059
*Notice the direction
of the tires.
(Left Hand Side)
Contact
Adhesive
*Notice the direction of the tires.
Make two the same for the left and 2 for the right.
Check the rotation direction before gluing.
Contact
Adhesive
34046