OFNA Racing 40991 Hong Nor RTR Radio - Manual (Page 10)

“HIGH” in START POWER mode parameter. With a “HIGH” start power mode you will have more low
end power and more wheel spin. So if you are on at loose track that don’t have a lot of traction you
might want to change the “START POWER” mode to Low 2 blinking green Led or Middle 3 blinking
green LED setting. (Refer to chart). Now to save your setting press the set button for 2 second, a
long beep will sound indicating setting is save now you can turn off your esc then turn on
Transmitter then turn on the esc to check your setting.
Changing Drag Brake
• Press and hold the set button on esc then turn on switch.
• Now indicating by 3 beeps “DDD”--- Release set button, LED turns Red and blinking one time,
now it’s at the 1st set mode (Reverse Power) now to go to “Drag Brake” quickly press the set button
again it should flash 2 time (Start Power) mode, press it again now it should flash 3 time
“Drag Brake” mode.
•To change the “Mode Parameter”Press and hold the set button again for one second, denoted by
long beeps, release set button. You are now in Parameter mode. Now each blinking green light
indicate what mode you in. As a default your esc should be blinking 1 time indicating your “Drag
Brake” is off. When your drag brake is off meaning when you are going forward and you let go
of the throttle your vehicle will still be rolling until you hit the brake. When you change the parameter
of the “Drag Brake” to Low, Middle or High is the amount of brake the esc will apply automatically
when you let go of the throttle. Low 30% 2 flashes, Middle 60% 3 flashes, High 90% 4 flashes of green
LED light. This is the amount of Drag Brake that will apply if you change the parameter.
•To save your setting press the set button and hold down for 2 second a long beep will sound
indicating your setting have been save. Turn off your esc, then turn on your Transmitter then turn
on esc and drive your vehicle and check your setting that you have changed.
Changing Battery Type
• Press and hold the set button on esc then turn on switch.
• Now indicating by 3 beeps “DDD”--- Release set button, LED turns Red and blinking one time,
now it’s at the 1st set mode (Reverse Power) now to go to (Battery Type) mode quickly press the set
button again it should flash 2 time (Start Power) mode, press it again now it should flash 3 time
(Drag Brake) press it again now you’re in (Battery Type) mode which should be blinking red 4 time.
• To change the “Mode Parameter”Press and hold the set button again for one second, denoted by
long beeps, release set button. You are now in Parameter mode. Now each blinking green light
indicate what mode you in. As a default your esc should be blinking 2 time indicating your’re
using “Ni-Cd/Ni-Mh” batteries. To change your battery type to “Lipo” quickly push the set button
again it should be blinking green 3 time, to change it again quickly push the set button it should be
blinking green 4 time indicating you’re in “Life” battery. (Refer to Chart on previous page).
• To save your setting press the set button and hold down for 2 second a long beep will sound
indicating your setting have been save. Turn off your esc, then turn on your Transmitter then turn
on esc and drive your vehicle and check your setting that you have changed.