OFNA Racing 40991 Hong Nor RTR Radio - Manual (Page 7)

Throttle Trim
•Throttle neutral adjustments can be made by moving the throttle trim to the left or the right.
•Racers Tip
When using a electronic speed control, please set the throttle trim to neutral and make adjustments to the speed control. On a gas powered
model, set the trim to the point where carburetor is fully closed in accordance with the engine instruction manual.
•Trim Operation and Travel
Trim adjustment will affect the overall servo travel, so please check the movement after the adjustment
When trim movement goes to extremes.
•That means if you have adjust the trim movement a lot to the neutral position, please recenter your servo horn closer to the neutral position
and inspect your throttle linkage.
FLASHING
•Finding Neutral position Throttle
1. Turn on transmitter
2. Push the “TH-TRIM” to the right (see Fig 5) and notice the “ST-DR” LED will start flashing Green (see Fig 6) then slowly turning to a flashing Red
hold it until you see a steady flashing Red, now you know you are at the end of the Forward trim.
3. To find the center or neutral position of the “TH-TRIM” push the “TH-TRIM” to the Left and hold it, you will notice that the “ST-DR” LED will start
flashing Green hold it their until you see that it will turn RED let go, now you are at center or neutral position, if you go past the RED light it
will start flashing GREEN again you are now off center or neutral and going toward the Reverse or Brake. If you past it don’t worry just push
it to the right a few click and you should be at neutral again.
HOW TO NEUTRAL THROTTLE TRIM
Fig 5
Fig 6
Right
Forward
Left
Reverse
Brake
Fail Safe
button
Fail Safe
Light
Fail Safe Process
1.Pair the transmitter and receiver before setting the fail safe(F/S) function. Turn on the transmitter power, then the receiver.
2.To set up fail safe(F/S) function with throttle servo is at neutral position, keep the throttle trigger at neutral position.
3.Press and hold the fail safe button on the transmitter for 5 second, until the fail safe LED light turn red. The fail safe(F/S) function is now
activated.
•The HNT-3 radio system features a built-in fail safe to
function automatically set the servo to default when the
transmitter loses signal due to interference.
For your safety ,we recommend you to active the fail safe
function.
CAUTION
•To avoid throttle servo position
must be at "neutral" when setting the fail safe(F/S) function.
• Fail safe is only good when you have power to the servo and
electronic speed control (ESC).
Without power it can not go
back to neutral.
losing control of the car, the
Stop
(Neutral)
Fail Safe Setup