Sangean DDR-62 (R1) - Manual (Page 13)

2
GB
If your network allows automatic configuration (which is normal) the radio will acquire a network
address. The screen should say ‘Connecting…’, and then ‘Setup wizard completed’. Press the
Select button to exit the setup wizard and show the main menu.
There are two indicator lights incorporated into the connector. If you have problems with your
wired connection, they may help you to identify the possible cause of the problem.
Yellow ON = Link established; OFF = no connection
Yellow Flashing = Data transfer
Green ON = 00 Mbits/sec link; OFF = 0 Mbits/sec ilnk
If your network does not support automatic configuration or if you wish to set it up manually then
you should select ‘[Manual config]’ instead of selecting ‘[Wired]’ in the Network Wizard.
.
2.
If you plan to use a WiFi connection, you will first need to identify your network in the list of
network names presented by the Network Wizard. If no networks are found then you may
have to get your wireless router working (please see the instructions supplied with it) or
you may be too far from the router. When the radio finds your wireless network, it displays
the Network Name (SSID) for the wireless access point on the screen. This is a name that
is allocated to the access point in your router by the person who set up the network – for
example: ‘Jones family’ or ‘Paul’s network’. If the router supports WiFi Proteced Setup, then
‘[WPS]’ will be shown in front of the SSID. It is possible, and in some locations highly likely,
that your radio will find more than one wireless network, in which case you should choose
which one you need to connect to.
Press the Folder Up or Down buttons on the remote control handset (alternatively, Tuning Up
or Down buttons on the touch panel) to see the SSID for each wireless network that has been
found. If your network is shown proceed to step  on the next page. If it is not shown then
proceed to step . If you make a mistake at any point, use the Back button to go back to the
previous screen.