Talkaphone VOIP-600H Single Button Help IP Call Station - Manual (Page 18)

VOIP-600 Series Phone
Configuration / Operation Manual
Page 18 of 94 Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
5. Enter Outbound Proxy details: If a separate outbound proxy is not being used please enter the SIP
registrar information again. (Secondary and Tertiary details can be assigned for failover)

Username: This is an optional field however it is required when Authentication is enabled on the
SIP registrar. Valid entries include alphanumeric and special characters (‘*’, ’.’, ’-‘, No spaces
allowed)

Password: This is an optional field however it is required when Authentication is enabled on the
SIP registrar. Valid entries include alphanumeric and special characters (‘*’, ’.’, ’-‘, No spaces
allowed)

IP Address and Port: Configure the IP Address and Port of the SIP registrar on which you want
to register the phone. Default port is 5060. Valid port range is 1024-49151.

Re-registration Time: Configure the registration refresh time. On expiration of this time interval,
the phone automatically sends a new register request to the registrar. Default re-registration time
is 3600 seconds. Valid range is 10-14400 seconds.
6. Click Apply. The following type of registration status appears based on your selection:

Registering as <Phone Number> @ <Domain Name> - Registration is in progress with SIP registrar.

Registered as <Phone Number> @ <Domain Name> - Registration is completed and phone is able
to receive incoming calls on the registered phone number.

Unregistered as <Phone Number> @ <Domain Name> - Phone is not registered for incoming calls.
Outbound calls can still be established via outbound proxy.