Talkaphone VOIP-600H Single Button Help IP Call Station - Manual (Page 44)

VOIP-600 Series Phone
Configuration / Operation Manual
Page 44 of 94 Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
iii. Select Guard Answers Call to play the voice message to remote side when the remote phone
answers the call.
iv. Select and enter the Key Code sequence entered by remote side to play the voice message to the
remote side when the corresponding key sequence is entered by the remote side during an active
call.
3. Select Looping – Yes/No to loop the voice message until the “stop message” event occurs.
4. The selected voice message stops playing on selection of the following events:
i. Select Auxiliary Input Activation/Deactivation events to stop playing the current voice message
on activation/deactivation of an Auxiliary Input Device.
ii. Select and enter the Key code sequence entered by Remote Side to stop playing the voice
message to remote side when the corresponding key sequence is entered by the remote side during
an active call.
5. Click Apply to save settings.
Note You cannot use the same event to activate and deactivate the same voice message.
6.