BendixKing KLN 94 - Quick Reference Guide - Manual (Page 7)

• To temporarily declutter the map, press
E
once to deselect land
data, press
E
a second time to declutter aero data. To restore,
press
E
again or leave the NAV 4 page and return to it.
• To configure what information is displayed on the map, press the
M
button, select Setup Aero Data? or Setup Land Date Menu? and
press the
F
button to bring up the appropriate Setup page (SET 7
for aero data and SET 8 for land data). The range selected on these
SET pages is the maximum range scale that the selected item will be
displayed on the map.
• To change the map orientation, press the
M
button, move the cursor
over item 3 and turn the right inner knob to select the desired orienta-
tion:
N
↑
= North up
TK
↑
= Actual track up (when groundspeed > 2 kts)
HDG ↑ = Heading up (if heading supplied to the KLN 94)
DTK
↑
= Desired track up
• To change the map scale factor:
1. Press the
R
button. The top half increases the map scale and the
bottom half decreases the map scale. The scale is displayed in the
bottom left part of the map.
2. For terminal area operations select AUTO scale factor by pressing
the
R
button for 2 seconds.
• To change the navigation information shown in the lower left corner of
the display:
1. Press the
B
button.
2. Use the right outer knob to move the cursor to line 4 or line 5 in the
the lower left corner.
3. For line 4, use the right inner knob to select between actual track
(TK), bearing, radial, or groundspeed.
4. For line 5, use the right inner knob to select between groundspeed,
ETE, crosstrack correction, or VNAV status.
- 7 -
KLN 94 Quick Ref R2 4/3/02 1:55 PM Page 2