BendixKing KLX 135 - Quick Reference Guide - Manual (Page 2)

D
To go Direct To a waypoint:
1. Press the
D
button. The Direct To (DIR) page will be displayed with a way-
point field.
2. Enter desired waypoint using right concentric knobs.
3. Press
F
to view waypoint information. Press
F
again to confirm.
This initiates the Direct To—your D-bar will be centered, and you’re on your way!
4. Alternatively, display desired waypoint on APT, VOR, NDB or SUP page, or
move the cursor over desired waypoint in the active flight plan, then press
D
,
then press
F
to confirm.
To initialize the position from the SET 1 page:
1. Press the
B
button to bring the cursor on the page over the INIT POS: field.
2. Using the right inner and outer knobs, enter the identifier for the airport where
you are presently located or the identifier of a navaid or other airport which is
close to your present position.
3. Once you have entered the complete identifier, press
F
. The display will
change to the waypoint page for the waypoint you entered.
4. If this is the waypoint you intended to enter, press
F
again. The display will
change back to the SET 1 page.
NOTE: As an alternative, you can also enter the approximate latitude and longitude
of your present position directly on the SET 1 page instead of entering a way-
point.
5. With the right inner knob, position the cursor over Ok?, if it is not already there,
and press
F
.
-2-
KLX 135.R4 5/16/03 2:33 PM Page 4