BendixKing KLX 135A - Quick Reference Guide - Manual (Page 5)

How to QuickTune™ a COMM frequency from the data base:
1.
Locate the page for the facility you desire to communicate with (APT,
FSS or CTR). The APT 4 page displays the frequency type (TWR =
Tower Freq, GRND = Ground Control, etc.) and frequency (Figure 6).
2. Press the
B
button to turn the cursor on and use the right outer knob
to scan through all the airport’s frequencies (Figure 7). There may be
more frequencies than can be displayed at one time.
3. When you have the cursor over the desired frequency, press
F
and that frequency will become the standby frequency in the COMM
transceiver (Figure 8).
To adjust the volume by overriding the automatic squelch:
1.
Pull out on the small knob in the upper left cor-
ner of the KLX 135A (Figure 9). This will either
allow you to receive a distant, weak signal or
give you a noise reference by which to adjust
the volume.
2. Push the volume knob back in for normal squelch operation.
136.97 KDAL
118.00 ATIS 120.15
>Leg CLR 127.90
APT+4 GRND 121.75
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
GPS
KLX 135 B
COMM
Pull
25K
Pull
TEST VOL
OFF
ENT CLR MSG D
CRSR
Pull
SCAN
136.97 KDAL
118.00
ATIS 120.15
ÉÑ>Leg CLR 127.90
APT+4 GRND 121.75
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
GPS
KLX 135 B
COMM
Pull
25K
Pull
TEST VOL
OFF
ENT CLR MSG D
CRSR
Pull
SCAN
136.97 KDAL
120.15 ATIS 120.15
>Leg CLR 127.90
APT+4 GRND 121.75
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
GPS
KLX 135 B
COMM
Pull
25K
Pull
TEST VOL
OFF
ENT CLR MSG D
CRSR
Pull
SCAN
B
Pull
TEST VOL
OFF
-5-
Figure 6
Figure 7
Figure 8
Figure 9
KLX 135A 5/16/03 2:48 PM Page 6