CANOGA PERKINS 2340 Universal Fiber Optic Modem - Manual (Page 34)

Model 2340 Model User Manual 4-10
4.9 Alarm Output Configuration
Use the Alarm Output Configuration screen to set any or all alarms to Major, Minor, or Off. See
Figure 14 and Table 15.
To configure alarms, follow these steps:
1. From the System Configuration menu type 4, "Alarm Output Configuration," and press <Enter>.
The Alarm Output Configuration screen appears.
2. Type the number for the alarm you want to set and press <Enter>.
3. Press <Space> to cycle to Major, Minor, or Off, and press <Enter>.
4. To return to the System Configuration menu, press <Esc>.
-------------------ALARM OUTPUT CONFIGURATION----------------------------
1) Factory Defaults
2) LOS/CLS Alarm Off
3) SQL Alarm Off
4) Configuration Alarm Off
5) Power/Fan Alarm Minor
6) Power-On Self Test Alarm Major
7) BERT Alarm Minor
Figure 14. Alarm Output Configuration Screen
Table 15. Alarm Output Definitions
Alarm Description
1) Factory Defaults Reset all alarms to factory defaults, for values, see Figure 14
2) LOS/CLS Loss of Signal (electrical)/Composite Loss of Signal (optical); one or
both received signals fail; default is Off
3) SQL Squelch (for received signal); default is Off
4) Configuration Setup errors, including mismatches with other modems; default is Off
5) Power/Fan Power is low or fan is off; default is Minor
6) Power-On Self Test Modem failed when power was turned on; default is Major
7) BERT Bit Error Rate Test (BERT) detects data errors; default is Off