CANOGA PERKINS 9160 10 Gigabit Ethernet Network Interface Device - Manual (Page 11)

LED Status Description
MGR Off No power
Green Normal operation
Green blinking Management traffic
Amber System self-test or over-temperature trap or alarm
Amber blinking Management traffic with over-temperature trap or alarm
Red Diagnostic or CPU failure
Table 2. 9160 Interface LEDs
LED Status Description
TX Off No transmission activity
Green blinking Transmission activity
Amber System self-test
Red Port disabled; may be due to Link Loss Forwarding (LLF)
RX Off No link
Green Link established; full duplex (if available)
Green blinking Receiving activity; full duplex (if available)
Amber System self-test; half duplex (if available)
Amber blinking Half duplex (if available) receiving activity
Red Receiving Remote Fault
NET Off Non-network connection
Green Network connection
Amber System self-test
SPD Off 10BaseT data rate
Amber 100BaseT data rate or system self-test
Green 1000BaseT data rate
Red Port disabled
Alarms
The 9160 can generate Traps and Major and Minor Alarms. For details about the Traps Log and
setting up notification, see Chapter 3.
9160 10 Gigabit Ethernet Network Interface Device 2-3