CANOGA PERKINS L357 ESU - Manual

Quick Start Guide
L357 ESU
Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com
P/N 6942590 Rev A Page 1 of 8
Overview
This document provides instructions for installation and initial configuration of the Canoga
Perkins model L357 ESU (Ethernet Service Unit).
The EdgeAccess L357 Ethernet Service Unit
is a managed Ethernet and Fast Ethernet Compliant device that supports native 10Mbps,
100Mbps and 1000Mbps Transparent LAN extension circuits. The L357 offers 10/100/1000 auto
sensing or software configurable User Interface and a variety of optical network interfaces. The
L357 is modular and hot swappable with a common form factor to mount in Canoga Perkins’
Carrier Class Universal Chassis System (UCS) as well as a variety of Customer Premise
Enclosures (CPE).
Parts List
1 x L357-xxxx
1 x UCS 1000 or UCS 1002 chassis
1 x UCS 1001 chassis
1 x UCS 1230 BAM (Bus Access Module)
1 x Model 1020-xxxx (management access CPE) or 1030-xxxx (unmanaged CPE)
1 x EIA-232 serial cable (straight)
1 x EIA-232 to DB9 converter (Canoga Perkins p/n CRJ-D9F-10)
Step 1: Unpacking
Unpack the L357 and check the unit for damage. If the unit is damaged, contact Canoga Perkins’
Tech Support line, (800) 360-6642, and ask for an RMA.
Step 2: Module Set Up
Before installation into a chassis or enclosure, you must verify the application in which the L357
will be used, i.e. 10Mbps, 100Mbps or 1000Mbps Ethernet, managed or non-managed etc. The
application may require setting the dip switches located at the rear of the L357. If the unit is to be
installed in the UCS 1030 enclosure, set the L357 to the desired configuration using Table 1 as a
reference. Otherwise, the L357 can be configured through software to the desired configuration
when installed in the UCS 1000, 1001, 1002 or 1020.
Figure 1. L357 Switches and Default Setting