Daiwa TANACOM BULL 500 - Manual (Page 24)

22
4.
Press the MODE BUTTON to go back to depth readout.
1
2.
Press MODE BUTTON again.
3. Set speed with the power lever.
1. Press MODE BUTTON .
3
MAX
OFF
Pickup speed preference
If the display is at display, then move the power lever
or press RESET BUTTON to show the display shown on the
right.
This display is the pickup setting display.
Use
While the power lever is at MAX position,
pressing the BPICKUP BUTTON makes the
motor run at the pre-set pickup speed.
Attention
1. While the BPICKUP BUTTON is in use for winding, winding speed is not displayed.
(the figure corresponds
to the case of setting to 5)
Functional setting operation
(6. Pickup speed setting)
4
2