Daiwa TANACOM 1000 - Manual (Page 12)

10
Attention
2. The motor can be overloaded when winding at very high tension for a long time (about 15
minutes). In this case, the motor will automatically stop. This does not occur while fishing
as water helps cool down the motor. If the motor stops, wind manually or move the
power lever momentarily back to OFF and then resume winding. Wind the line at high
speed (less tension).
Line data input
(When line length is known)
This method is used when the line length is known before winding. In the example below,
PE 6 – 1000m is wound.
1.
Run line through the levelwind guide and tie it onto the spool.
The levelwind threader makes this process easier. Make sure to
tie the line onto the pin found on the spool to avoid the line
slipping.
4
MAX
1
2
4. Push the power lever forward to maximum and wind the line to
its end.
As the power lever is moved forward, the P1 display changes to a
tension indicator. Keep line tension between level 5 and 7 while
winding on line.
2. Move the power lever to the OFF position.
3. Press the MODE SETTING BUTTON and hold for five
seconds, until the display shows 0.0 . When the button is
released, the display will then change to the figure on the right,
which shows P1 .
Make sure the drag is set firmly.
Levelwind Guide
Main line
Pin
Power lever
3
Tension indicatar
1.Do not allow line to rub against the palming plate while winding as it could scratch the plate.