Dynon Avionics EFIS-D60 Installation Guide - Manual (Page 42)

Appendix
5-16 EFIS-D60 Installation Guide
directly to your switched avionics power. Ensure that all avionics power is off before performing
the wiring step of this installation.
If your Altitude Transponder has either a strobe signal or a D4 pin, leave these pins unconnected.
Transponder Pin Encoder Converter
Wire Color
A1 Yellow
A2 Green
A4 White with Blue
B1 Blue
B2 Orange
B4 White with Red
C1 White with Green
C2 White
C4 White with Black
Power (10V-30V) Red
Gnd Black
Strobe Signal No Connection
The Gray code output of the Encoder Converter reports altitude not adjusted for barometric
pressure, as required by FAA specification. The altitude reported by the EFIS-D60 encoder will
always match the altitude shown on screen when the BARO value is set to 29.92 inHg.
STEP 2: CONNECTING TO THE EFIS-D60
Before wiring connections to the EFIS-D60 check to ensure that the wire length between your
Encoder Converter and your EFIS-D60 is appropriate. Add or remove wire length if needed or
desired. Customizing the wire length will facilitate an installation that is both cleaner and more
secure.
The only pins of interest on the EFIS-D60 connector for the Encoder Converter installation are
pins 13 and 21. The two wires exiting the Encoder Converter are the EFIS-TX and the EFIS-
Ground, which are green (or red) and black respectively, and 2 feet in length. Connect these
wires to the EFIS-D60 25-pin female harness.
Ensure that your EFIS-D60 is powered off. Then connect the black EFIS Ground wire to pin 21.
Then, connect the green wire to pin 13 (Serial Encoder Transmit) on the EFIS harness.