Leica Geosystems Roteo 20HV, 25H, 35, 35G - Manual (Page 10)

7 Set-up and applications Roteo 20HV/25H/35/35G - 1.2.0en
D
EN
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
H
RUS
CZ
Two modes are available:
• Full manual mode – Both the X and Y-axes will be in
manual mode
• Semi-automatic mode – The X-axis self-levels, The Y-
axis is in manual mode.
For slopes up to 10%, set up the laser in horizontal mode
and use the remote to set the slope following the instruc-
tions below.
For slopes greater than 10%, set up the laser in vertical
mode and use the inclined plane feature explained in the
following section.
Set-up for full manual mode
In full manual mode, the unit will not self-level and the
head will continue to rotate. The plane of laser light can
be tilted in either one or both planes.
To use the laser in full manual mode:
X After turning the laser on and allowing it to self-level,
press the Auto/Manual key {B-1}. The X-axis LED
{B-10} above the key will blink red rapidly, indicating
that you are in manual mode and you can set slope in
the X-axis. (The Y-axis LED will also be on and red.)
X Turn the laser so that the X on the top of the laser
faces the direction of the slope.
X Press either CCW/CW (manual slope) keys {B-6 or
B-7} to adjust the slope of the X-axis.
X To adjust the slope of the Y-axis, press the Auto/
Manual key {B-1} again. The Y-axis LED {B-10}
above the key will blink red rapidly, indicating that you
are in manual mode and you can set slope in the Y-
axis. (The X-axis LED will also be on and red.)
X Turn the laser so that the Y on the top of the laser
faces the direction of the slope.
X Press either CCW/CW (manual slope) keys {B-6 or
B-7} to adjust the slope of the Y-axis.
X Press the Auto/Manual key {B-1} for 1.5 seconds to
exit manual mode and return to automatic mode. See
illustration {J} in the back, inside cover of this manual.
Set-up for semi-automatic mode
In semi-automatic mode, the unit will self-level in the X-
axis. The plane of laser light can be tilted manually in the
Y-axis.
To use the laser in semi-automatic mode:
X After turning the laser on and allow the laser to self-
level, press and hold the Auto/Manual key {Roteo 35/
35G: B-1, Roteo 20HV/25H: E-3} for three seconds.
Roteo 20HV/25H: The X-axis LED {B-10} above the
key will blink green slowly while leveling. The Y-axis
LED will blink quickly indicating that the Y-axis is in
manual mode and you can set slope in the Y-axis.
X Turn the laser so that the Y on the top of the laser
faces the direction of the slope.
X Press either CCW/CW (manual slope) keys {B-6 or
B-7} to adjust the slope of the Y-axis.
X Press the Auto/Manual key {B-1} again to exit semi-
automatic mode and return to automatic mode.
Set-up for inclined planes (Roteo 20HV/35/
35G)
The Roteo can also be tilted, for manual slope, at various
angles on the wall mount. A tripod with rotating mounting
plate will speed set-up.