Electromagnetic compatibility (emc), Fcc statement (applic. in u.s.) – Leica Geosystems Leica DISTO D2 User Manual

Page 13

Advertising
background image

10

Appendix

Leica DISTO™ D2 762960 en

EN

F

E

P

* Use a target plate to increase the measurement range
during daylight or if the target has poor reflection properties!
** in favourable conditions (good target surface properties,
room temperature) up to 10 m (33 ft). In unfavourable condi-
tions, such as intense sunshine, poorly reflecting target
surface or high temperature variations, the deviation over
distances above 10 m (33 ft) can increase by ± 0.15 mm/m
(± 0.0018 in/ft).

Electromagnetic Compatibility
(EMC)

The term "electromagnetic compatibility" is taken to
mean the capability of the product to function
smoothly in an environment where electromagnetic
radiation and electrostatic discharges are present,
and without causing electromagnetic interference to
other equipment.

ƽ

WARNING
The Leica DISTO™ conforms to the most strin-

gent requirements of the relevant standards and
regulations.

Yet. the possibility of the product causing interfer-
ence in other equipment cannot be fully excluded.

FCC statement (applic. in U.S.)

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful inter-
ference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be deter-
mined by turning the equipment off and on, the user
is encouraged to try to correct the interference by
one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment
and receiver.

Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV
technician for help

ƽ

WARNING:
Changes or modifications not expressly

approved by Leica Geosystems for compliance could
void the user’s authority to operate the equipment.

Dimension

111 x 43 x 23 mm

4.37 x 1.69 x 0.90 in

Weight

100 g

Temperature range:
Storage

Operation

-25°C to +70°C

(-13°F to +158°F)

0°C to +40°C

(32°F to +104°F)

Advertising