Leica Geosystems TPS800 DXF Export - Manual (Page 5)

TPS400 and TPS800 DXF Data Output Page
5
Surveying
Use the Surveying Programme the TPS400 or TPS800 to record the data so that it can
be output as Co-ordinates.
MENU, F1 Programs, F1 Surveying
Use the
F2 Set Station option to use Co-ordinates uploaded to the TPS400 or TPS800
prior to going to the field, or to enter the Co-ordinates manually.
The
F2 Set Station option should be used for each new Instrument Set Up. A DXF file is
a file of co-ordinates and the Station and Orientation data is required for the
computation of the co-ordinates of the points for the DXF file. The program will use
the computed bearing from the Instrument Station co-ordinates to the RO Station co-
ordinates, or the input Angle, to set the orientation of the Instrument.
Codes
The Codes placed in the layer
CODE are the contents of Code field in the Codelist.
The Code must always be recorded before the Measurement.
Typical Usage
Use
MENU
F1 Programs
F1 Surveying
F1 Set Job to put in the name of the job file in which the data will be recorded
F2 Set Station to enter or select the co-ordinates for the occupied station
F3 Set Orientation to enter the information for orientation of the Instrument
F4 Start to record the points of interest with the relevant coding if required.
Leica Geosystems Limited,
Davy Avenue, Knowlhill, Milton Keynes, England, MK5 8LB.
www.leica-geosystems.com
HA
March 2005