Magliner EXTRACTOR HANDLE - Manual (Page 4)

4
5. Repeat Steps 3 and 4 for the other side of the hand truck.
6. Making sure that the leg is trapped in the corner of the mounting bracket and the side rail as stated in Steps
3 and 4, align and slide each of the retaining clips down onto the legs of the springs so that 1/2” of the
spring legs are behind the retaining clips as shown in figure 5.
7. Tighten the mounting bracket lock nuts on both sides.
8. Make sure the extractor handle springs back into position after use with a gradual movement.
©Copyright Magline, Inc. 2012 B9273
Figure 5
I