Panasonic NI-636E - Manual (Page 2)

IMPORTANT SAFEGUARDS
When using your flatiron, basic safety precautions should always be followed,
including the following
1 Read all instructions
2 Use iron only for its intended use
3 To protect against a risk of electric shock, do not immerse the iron in water
or other liquids
4 The iron should always be turned to OFF before plugging or unplugging
from outlet Never yank cord to disconnect from outlet, instead, grasp plug
and pull to disconnect.
5. Do not allow cord to touch hot surfaces Let iron cool completely before
putting away
Wind cord into cord reel unit when storing (NI-486E/NI-686E Only)
Loop cord loosely around iron when storing (NI-436E/NI-636E Only)
6 Always disconnect iron from electrical outlet when filling with water or
emptying and when not in use
7 Do not operate iron with a damaged cord or if the iron has been dropped
or damaged To avoid the risk of electric shock, do not disassemble the
iron, take it to a qualified serviceman for examination and repair
Incorrect reassembly can cause a risk of electric shock when the iron is
used.
8 Close supervision is necessary for any appliance being used by or near
children Do not leave iron unattended while connected or on an ironing
board
9 Burns can occur from touching hot metal parts, hot water.or steam Use
caution when you turn a steam iron upside down - there may be hot
water in the reservoir
SPECIAL INSTRUCTIONS
1 To avoid a circuit overload, do not operate another high wattage appliance on
the same circuit.
2 If an extension cord is absolutely necessary, a 10 ampere cord should be
used Cords rated for less amperage may overheat Care should be taken to
arrange the cord so that it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS
© 1995 Matsushita Electric Industrial Co., LTD All rights reserved
-2-