Panasonic NI-636E User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO USE AS A STEAM IRON
1
Fill the iron as described in "HOW TO FILL"
2
Set the iron vertically and make sure the temperature selector dial is set to OFF
Plug the AC cord into the electrical outlet
3
Set the temperature selector dial to the desired position Normally it is sufficient
to set the selector dial to the "O " or " (steam) zone
"O " zone low steam, for thin or delicate fabrics requiring a small amount of steam
"^"zone high steam, for fabrics requiring a lot of steam (i e thick materials,
Items with stubborn wrinkles )
4
{NI-636E/686E Only)
Preheat the iron usually in about 1-2 minutes
(NI-436E / 486E Only)
Preheat the iron until the indicator light goes out This light,will go on and off during
ironing to indicate the temperature chosen by the selector dial is being maintained
5
Hold the iron horizontally and press the steam button into the steam position
Steam button is regulated as follows
NOTE 3 position steam button
G
Dry Low steam High steam
D
(Button UP for High steam MED for Low steam)
Now steam ironing can begin
6
Anytime the iron is set vertically the steaming action will stop
NOTE Do not use the steam button unless the iron is sufficiently hot enough to produce
steam, otherwise water will leak out through the vents instead
- 6 -