Connect the aerial cable to the rf in terminal, Battery installation, Safety instructions) – Panasonic TX21FJ50M User Manual
Page 2: Before operating this set
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Dear Panasonic customer
Welcome to the Panasonic family of customers. We hope that you will have many years of enjoyment from your
new colour television.
(^Safety Instructions)
The TV set can be operated on AC
AUTO 110-240V, 50/60HZ (TX-
21FJ50M) or AC SINGLE 230-
240V, 50Hz (TX-21FJ50A).
The apparatus shall not be
exposed to dripping or splashing
and that no objects filled with
liquids, such as vases, shall be
placed on the apparatus.
Do not remove the rear cover, as
live parts are accessible when it is
removed.
Remove the plug from the wall
outlet (Power point) when the TV
set is not used for a prolonged
period of lime.
The cabinet and picture tube can
be kept in good condition by simply
wiping with a clean, soft cloth
moistened with mild detergent and
water. Do not use solutions
containing benzol, petroleum or a
chemical cloth. For safety, remove
the plug from the wall outlet.
Adequate ventilation is essential to
prevent failure of electrical
components.
Avoid exposing the TV set to direct
sunlight and other source of heat.
Do not use this set if abnormal
operation occurs.
EX: smoke, odd sounds or smells,
turn the power switch off and
disconnect the AC power if you
notice any unusual operation.
(Before Operating This Set ^
■ Connect the Aerial Cable to the RF In Terminal
To obtain the best quality picture and sound, an externa^
antenna, the correct cables (75 ohm coaxial) and the
correct terminating plug will be required.
If a communal antenna system is used, you may require
the correct connection cable and plugs between the wall
antenna socket and your television receiver.
Your local Television Service Dealer may be able to
assist you in obtaining the correct antenna system for
your particular area and accessories required.
Any matters about antenna installation, upgrading of
existing systems or accessories required, and the cost
incurred, are the responsibility of the customer.
■ Battery Installation
VHF Aerial
UHF
Two “R6 (AA)" size
Open the cover.
Insert the two batteries.
Close the cover.
A Cautions
Do not use rechargeable (Ni-Cd) batteries.
They are different in shape and performance and may fail to ensure correct operation.
The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote
Control or cause the batteries to burst.