Panasonic TX21FJ50M - Manual (Page 5)

(^General Operation)
10
f O O C J L J j
wim fp. iiDti iioio
® ®
© © 0
© © ©
© © ®
^ I ® ©*■
CZ3 cm —11 ft li
scmczDS
Q B CD
A
— V
©
To Switch Power on/off
The TV set must be switched on at the wall outlet and at the Main power
switch. ■
Press this button to turn the TV set ON, from stand-by mode. Press it
again to turn oft.
Power - indicator
STANDBY - RED
Power ON - GREEN
Note: When in the stand-by condition, it is possible to turn the TV set
on by pressing the Direct Programme Number Selection button
(0-9) or the Programme Number Up or Down button.
Programme Number Selection |-^----------------
1
Press the Programme Number Up "A” or Down “V” |a
button to select the next higher or lower
p
Programme Number.
Direct Programme Number Selection (0 - 9) pj—
e.g. To select Programme Number
“ 1 " ,
press the
I
“1" button.
Two Digit Programme Number Selection -----
e.g. To select Programme Number “18”. )
Press (©) button, button, then button. pri
1
Setting range 0-99
g rr-p| Volume Adjustment
—^ — Press the Volume Up “+” or Down button to increase or decrease the
sound volume level.
6 TV/AV T V / A V Selection
Press the “TV/AV” button to select TV, AV1, AV2 and COMPONENT input
signal modes sequentially.
I ^ 5 VOLUME
TV/AV
o
«
a
[ component
^ 5 VOLUME
The "Mute” symbol
will appear.
(Colour changes to
Red)
©
O
Sound Mute Button
Press this button to mute the Sound completely.
Press the button once again to restore the previous
sound level, and cancel the mute.
Recall Button
Press the RECALL button to display the current system status. Press this button until display is
cancelled.
Off-timer Button i
The TV set may be preset to switch to stand-by after a fixed period. j__________ ^
By pressing "Off-Timer” button, you can select the preset time either 30, 60,
or 90 minutes.
030
t-Q,
o
060 — 090
0 —Q auto 0
Note: Setting Off-Timer to AUTO mode. If the set is not switched off, when the TV station ends
broadcasting, it will automatically go to the stand-by condition after 5 minutes. This AUTO
mode will not operate when the TV receiver is in AV mode/DVD mode.
How to cancel the Off-Timer setting:
1. Set the preset time condition to “0" mode by pressing the Off-Timer button.
2. Turning the TV set off.
Normal ( N ) Button
By pressing the Normal “N" button on the Remote Control while Picture or Sound Control
Function is displayed, the selected function will be changed to the Normal Mode. Normalization
will not occur if the function is not displayed when the “N” button is pressed. The Normal mode is
the factory preset condition. Returning to this original condition is called “Normalization’’.
5