Panasonic SVGA Monitor/Receiver CT-36DV60 - Manual (Page 25)

Auto Program
The Auto Programming feature allows you to place
channels with a video signal into Channel Scan
Memory. When you press ^ or only those
channels with a video signal will accessed. TV or Cable
Tuning mode must be set properly for your system.
Set Up Features (cont’d.)
Heipfui Hints:
After Auto Programming:
Blue channel number indicates channel is in
Channel Scan Memory.
•All channels are available by direct access using the
Keypad numbers “0 through 9”.
After Auto Programming Scan has completed, up to
15 channels will be programmed into the FAVORITE
Channel Scan if space is available. Any original
channels
that were programmed into FAV
CHANNEL will remain. (Refer to Favorite Channel
Scan for deleting unwanted channels.)
1. Press
2. Press ^ or ^ and or ^ to highlight the
Set Up Icon.
3. Press ^3) to display the Set Up menu.
MODE._„ ___ _____ CABLE
AUTO PROGRAM ; [NO
MANUAL PROGRAM 'NO
CC ON MUTE NO
CC MODE OFF
PRESS CH ▼ FOR MORE
4.
5.
6 .
Press
A
or
W
to highlight AUTO PROGRAM.
Press or ^ to start Autp Programming Scan.
Channels will automatically advance until all
channels have been scanned.
Channel numbers with video signal present will
turn blue which indicates stored in Channel Scan
Memory.
7. Press twice to exit menus.
NOTE: Some channels with very weak signals may be
locked into memory. These must be deleted
manually using the Manual Program feature.
Manual Program
This feature allows you to select which channels are
placed into Channel Scan Memory so when you press
^ or ^ only those channels you desire will be
accessed.
1. Press the .
2. Press A or ^ and or ^ to highlight the
Set Up Icon.
3. Press to display the Set Up menu.
'S^W\
m
[Si
RRESSICHKSflF.ORlMORE
4. Press A or ^ to highlight MANUAL
PROGRAM.
5. Press or ^ to display Manual Programming
Menu.
6. Use the Remote Control Keypad numbers “0
through 9” or
A
or to select channels.
7. Press to add channel(s) to memory (blue).
Press the to delete channel(s) from memory
(yellow).
8. Repeat Steps 6 and 7 to continue adding or
deleting channels.
9. Press twice to exit menus.
-
24
-