Television location, Optional cable connections, Ac power supply cord – Panasonic CT 36G34 User Manual
Page 5: Cable/antenna, Antenna connection, Cable / antenna, Cable connection, Installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
nstallation
Installation
Television Location
This unit is intended to be used with an optional stand or entertainnnent center. Consult your
dealer for available options.
□
Avoid excessive sunlight or bright lights, including reflections.
□
Keep away from excessive heat or moisture. Inadequate ventilation may cause internal
component failure.
□
Fluorescent lighting may reduce remote control transmitting range.
□
Avoid magnetic equipment, including motors, fans, or external speakers.
Optional Cable Connections
Shielded audio and video cables should be used between components. For best results:
n Use 75-ohm coaxial shielded cables.
O Use appropriate input and output connectors that match your component connectors,
n Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE A PLUG WITH A
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE. FOR SOME MODELS THAT ARE
NON-POLARIZED, THE USE OF AN AC ADAPTOR CONNECTOR MAY
BE NECESSARY.
41:
Polarized plug
Cable/Antenna
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cable supplied by your local cable company.
Note:
A cable converter box may be required for proper reception.
Check with your locai cable company for compatibility
requirements.
Antenna Connection
Incoming Cable from
Cable Company
75 Ohm VHF/UHF
on back of TV
For proper reception of VHF/UHF channels, an external antenna is required. For
best reception an outdoor antenna is recommended.
Antenna Mode must be set to TV in the SETUP menu.
incoming cable from
Home Antenna
Cable Mode is preset at the factory.
Antenna users must change to Antenna
Mode in the Setup Menu.
S