Panasonic NV-L25 - Manual (Page 34)

NG)(CO
Connecting to a VHS/VHS-C Movie Equipped with
S^chm Edit Functioit
It is possible to synchronize the playback start and stop of
the VHS/VHS-C Movie with the recording start and stop of
this VTR.
Preparation
• Make the necessary connections as shown in the con­
nection diagram.
• Set the Edit Switch (Noise Fiiter/Edit Selector) on both the
VHS/VHS-C Movie and on this VTR to “ON” (or “EDIT
ON”).
^ Put the VTR in the recording pause mode.
@ Put the VHS/VHS-C Movie in the still playback mode.
• Put the Movie at the point where you want to start
editing into the still playback mode.
Q Press the Pause/Stil! Button on the VTR.
• The VHS/VHS-C Movie changes over to the playback
mode and the dubbing will start automatically. * •
!»i
(J) Press the Pause/Still Button on the VTR.
• The VTR changes over to the recording pause mode
and the VHS/VHS-C Movie changes over to the still
playback mode.
Operate the VHS/VHS-C Movie to skip the unwanted
scenes and then put it in the stilt playback mode again.
Press the Pause/Still Button on the VTR.
•The dubbing will restart.
To stop the dubbing, press the Stop Button on the VTR and
then put the VHS/VHS-C Movie in the stop mode.
:34)