Cub Cadet S6031 - Manual (Page 11)

11 s
ectiOn
2 — a
sseMbly
& s
et
-u
p
Install the upper ROPS section onto the lower ROPS “posts”. 4.
Install the (1⁄2-13 x 3.25) HHCS bolts, nuts and washers. See
Fig. 3-3.
Tighten Upper ROPS section bolts after both RH & LH 5.
hardware is installed.
Tighten the frame mounting hardware to 80-90 lb.-ft.
6.
torque. See Fig. 3-2.
NOTE: Make sure tubular upright posts are absolutely tight
within welded bracket.
Insert rubber plugs into each side of the upper ROPS. See
7.
Fig. 3-4.
Move the upper ROPS section to the upright position, and 8.
insert the locking pins with their retainer hairpin clips. See
Fig. 3-5.
Position Steering Wheel
The steering wheel of the tractor has been left off for shipping
purposes. Using the hardware found in the manual bag, the
steering wheel must be secured to operate the tractor. To install
the steering wheel for operation, proceed as follows:
Slide steering wheel over the steering shaft. See Fig. 3-6. 1.
Slide washer over steering shaft and secure using hex nut. 2.
Snap steering wheel cover onto steering wheel. 3.
Hex Bolts
Washers
Nuts
Lower ROPS Posts
Figure 3-3
Rubber Plug
Figure 3-4
Locking Pin
Hairpin
Clips
Figure 3-5
Steering
Shaft
Steering
Wheel
Washer
Hex Nut
Steering
Wheel
Cover
Figure 3-6