Panasonic CT-27SF34 - Manual (Page 33)

Set Up Features
Auto Programming - The Auto Programming
feature allows you to place all channels with a video signal
into Channel Scan Memory. When you press ^ or
only those channels with a video signal will be accessed.
NOTE: TV or Cable Tuning mode must beset properly for
your system.
1
.
2 .
Press .
^ or W and or^ to
Manual Programming - This feature allows
you to select which channels are placed into Channel
Scan Memory so when you press ^ o*" ^ only those
channels you desire will be accessed.
1. Press the
2. Press ^ or Wand'*€ or ^ to highlight the Set Up
Icon.
Press
Icon. or v and ^ or to highlight the Set Up 3 press to display the Set Up Menu.
3. Press iteiJJ to display the Set Up Menu.
4. Press
A
or ^ to
highlight
AUTO PROGRAM.
5. Press ^ or ^ to start Auto Programming Scan.
Channels will automatically advance until all channels
have been scanned.
• Channel numbers with video signal present will turn
blue which indicates stored in Channel Scan Memory.
6. Press twice to exit menus.
NOTE: Some channels with very weak signals may be
locked into memory. These must be deleted
manually using the Manual Program feature.
¡Ilelpful
After Auto Programming:
Blue channel number indicates channel is in Channel
Scan Memory.
All channels are available by direct access using the
Keypad numbers “0 through 9".
After Auto Programming Scan has completed, up to 15
channels will be programmed into the FAVORITE
Channel Scan if space is available. Any original
channels that were programmed into FAV CHANNEL
will remain. (Refer to Favorite Channel Scan for
deleting unwanted channels.)
4. Press
A
or W to highlight MANUAL PROGRAM.
5. Press or ^ to display Manual Programming
Menu.
6. Use the Remote Control Keypad numbers “0 through
9” or
A
or
W
to select channels.
7. Press ^ to add channel(s) to memory (blue). Press
the to delete channel(s) from memory (yellow).
8. Repeat Steps 6 and 7 to continue adding or deleting
channels.
9. Press twice to exit menus.
- 3 3 -