Panasonic KX-TG9150E - Manual (Page 8)

Preparation Preparation
Battery charge
Place the handset on the base unit for
about 7 hours before initial use.
When charging,
“Charging” will be
displayed.
When the batteries are fully charged,
“Charge Completed” will be displayed.
• While charging, the charge indicator on
the handset lights in amber. When the
batteries are fully charged, the charge
indicator lights in green.
Charge
contact
Note:
• It is normal for the handset to feel warm
during charging.
• If you want to use the unit immediately,
charge the batteries for at least 15
minutes.
• Clean the charge contacts of the handset
and base unit with a soft, dry cloth once a
month, otherwise the batteries may not
charge properly. Clean more often if the
unit is exposed to grease, dust, or high
humidity.
Battery strength
Battery icon
‘ "a
Battery strength
high
a
Medium
□ Low
When flashing; Needs
to be charged.
Panasonic Ni-MH battery performance
(included batteries)
Tyrning the power on/off
Operation
In continuous use
Operating time
15 hours max.
In continuous
standby mode 240 hours max.
Note:
• It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
• Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
• Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
• Even after the handset is fully charged,
the handset can be left on the base unit
without any ill effect on the batteries.
• The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit and charge for at least 7 hours.
Screen sa¥er mode
The backlight will turn off completely
after 1 minute of inactivity if the handset is
not on the base unit.
To use the handset when it is in screen
saver mode, first press [%®] to turn the
display on again.
Power on
Press until a short beep sounds.
Power off
Press [%©] for about 2 seconds.
Symbols used in these
operating instructions
Symbol
im ' ' '
Meaning
IjHij (©eilu'H Oi iOySiiCk;
Proceed to the next operation.
год Press glTI (centre of joystick).
Select the mentioned handset
и menu icon (page 11).
% Exampie: | (handset setup
e menu icon)
e Select 1 by pushing the
i joystick in any direction.
Select the words in quotations
shown on the display (e.g.,
“Time Settings”) by
pushing the joystick up or
down.
Display language
1 [74©] —> El (centre of joystick)
2 Select i by pushing the joystick in any
direction. —> ВШ (centre of joystick)
3 Push the joystick up or down to select
“Display Setup”. —)■ МЯ
4 Push the joystick up or down to select
“Select Language”. ■—>• 1«1Я
5 Push the joystick up or down to select
the desired language.—> ГОД —>
[74®|
Note;
• If you select a language you cannot read,
press [ТЧ®], press tttl. select press
ГОД, push the joystick down 2 times,
press 03. push the joystick down 2
times, press ГОД, select the desired
language, then press ГОД Press [%©].
14 Helpline Tel. No.; U.K. 08700 100 076 R.O.l, 01289 8333 Helpline Tel, No.: U.K. 08700 100 076 R.O.l. 01289 8333 15