Yamaha pw80 - Manual (Page 29)

3. Remove the number plate.
4. Remove the handlebar.
5. Remove the front wheel. (Refer to page
32.)
6. Remove the cap bolt from the inner tube.
7. Loosen the pinch bolt.
8. Remove the front fork.
9. Drain the fork oil.
10. Installing the front fork on the machine.
Bring up the front fork to the correct po­
sition and partially tighten the underbrack­
et pinch bolt.
Pour specified amount of oil into the in­
ner tube through the upper end opening.
Recommended oil:
Yamaha fork oil 15 wt or equivalent
Capacity per leg:
60 cm^ (2.1 Imp oz, 20 US oz)
Pinch bolt torque:
33 Nm (3.3 m-kg, 24 ft-lb)
NOTE:______________________________
Select the weight oil that suits local conditions
and your preference (lighter for less damping;
heavier for more damping).
11. After filling, slowly pump the outer tube
up and down to distribute the oil.
NOTE:___________ ^__________________
Adjust the oil levels in both right and left front
forks so they are even.
12. Inspect 0-ring on fork cap bolt and
replace if damaged.
Install the fork cap bolt and torque to
specification.
Fork cap bolt torque:
40 Nm (4.0 m • kg, 29 ft • lb)
1. Cap bolt 2. 0-ring
13. Install the front wheel. (Refer to page 32.)
14. Install the handlebar.
Handle holder upper torque:
13 Nm (1.3 m.kg, 9.4 ft-lb)
15. Install the number plate and the brake ca­
ble clamp.
REAR SHOCK ABSORBER (MONOCROSS
SUSPENSION "DE CARBON" SYSTEM)
A WARNING
This shock absorber contains highly com­
pressed nitrogen gas.
Read and understand the following infor­
mation before handling the shock ab­
sorber. The manufacturer cannot be held
responsible for property damage or per­
sonal injury that may result from improper
handling.
-17-