Yamaha FX770 User Manual
Page 61
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 7: Reference
Parameter #
'Name
Function
Value/Range
Parameter 1
TEMPO
Tempo
J
=50 - 250
Parameter 2
NOTE
Note Length
Parameter 3
Ffl
Feedback
0~ 100[%]
Parameter 4
SPD
Modulation Speed
0.1 ~ 20.0 [Hz]
Parameters
DEP
Modulation Depth
0~ 100[%]
Parameters
MIX
Mix Balance
0- 100[%]
Parameter 7
LVL
Output Level
-CO, -30 ~ +6 [dB]
Parameter 8
TRG
Trigger
OFF, FS2, MIDI
Parameter 9
HF
High Frequency Ratio
1-10
Notes:
Tempo
Note Value
Feedback
Modulation Speed
Modulation Depth
Mix Balance
Output Level
Trigger
High Freq. Ratio
Sets the Tempo for delay. You cannot set the Delay Time to 670ms or longer. If you set the TEMPO to
under 90 with Note set to a quarter note, Delay Time becomes 670ms, and the TEMPO value will flash.
Selects the Note length
Controls the amount of repeats.
Controls the rate (Speed) of the modulation effect.
Controls the depth of the modulation effect on the delays.
Mixes between the Dry signal and the Delay effect (Setting this to 100% will produce only the chorus
effect.)
Overall Level of this Effect Block
Selects the Source of external control for the Tempo parameter. You can adjust the TEMPO parameter
value using the footswitch (by selecting FS2) or using the MIDI clock (by selecting MIDI).
A “tape-echo” EQ for the delays. As the value increases, the high range of the repeated sound attenuates
gradually, resulting in a very natural echo.
NOTE
(OFF)
58