Panasonic RS-TR252 - Manual (Page 5)

Please check and identify the supplied
accessories
I j
AC power supply cord,
(For Australia
and N.Z.) (For others)
1 Stereo connection
cables...................
I I
Power plug adaptor...............
1
(Not supplied for Australia
and N.Z.)
Before making connections, make sure that the power to this unit
and all other system components is turned off.
• Avoid letting the cables touch each other as much as possible,
otherwise noise wilt be generated.
• Although the figure below shows the AC power supply cord be­
ing connected to a household AC outlet, if the amplifier (or
receiver) is equipped with an AC outlet, connect the cord to that
outlet.
Placement hints
If this unit is placed near a receiver or a tuner, a "hum” noise
may be heard during tape playback, recording, or AM reception
of the receiver or the tuner.
If this occurs, leave as much space as possible between the
units, or place them where there is the least amount of “hum”.
(For areas except Australia and N.Z.)
Set the voltage selector to the voltage setting for the area
in which the unit will be used.
(Use a minus (—) screwdriver]
If the power supply in your area is 117 V or 120 V, set to
the “127 V” position.
Note that this unit will be seriously damaged if this setting
is not made correctly.
If the power plug will not fit your socket,
use the power plug adaptor (included).
—
stereo connection cable
White (L) =aHK, HD=
Red (R) _ J
Amplifier
or receiver
(For areas except Australia and N,Z.)
Insertion of Connector
Even when the connector is perfectly in­
serted, depending on the type of inlet used,
the front part of the connector may jut out
as shown in the drawing,
However there is no problem using the unit.
Connector
Household
AC outlet