Panasonic TOUGHBOOK CF-28 - Manual (Page 15)

tWindo^NTv
Select your operating system _____
Select [Windows NT Workstation Version 4,00] and press ( Enter ^.
CWindo^NTK
Logon
Press C Ctrl ) + ( Alt) + C Del).
iWindow^2000|IiWJ ndo^
Input your password
Wait for 10 seconds after confirming that the hard disk access has been completed, and
input the user name and password, then select [OK]. Until the correct user name and
password are entered, the computer will not operate.
iWitidow^Mlii
If [Cancel] is clicked, the computer will return to the initial [Begin Logon] display.
Select your application
You are able to start working on your computer.
note )-
The power saving function is factory set, so if there is no input from a key, the touch pad,
the touchscreen or an external mouse (when one is connected) for a certain interval of
time, the power to the LCD and hard disk may be turned off. The LCD will resume opera­
tion when the touch pad, the touchscreen or an external mouse (when one is connected) is
used or a key is pressed.
The power to the LCD may be turned off while Windows is setting up or even when an
application software is being installed. In this case, because it is conceivable that a selec­
tion dialog box will be shown, do not press C Space ) or C Enter) to attempt to resume
from this condition as doing so may trigger a selection, but instead, press a key unrelated to
the direct triggering of a selection, like C Ctrl ).
4W.I ndQW^98inWi ndov(^
In addition, when the computer is left alone, it automatically enters the standby* mode
(C^ ‘"Standby/Hibemation Functions”). The computer will resume by rotating
the power switch.
4Wjndows)2000i : standby or hibernation
15