Focus or flange-back adjustment – Panasonic WV-BP310 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(3) Set the Lens Selection Switch (9) to the proper
position as follows.
DC: The mounted lens is one of the lenses listed
on pages 10, 11, 12 and 13 or one that
requires the DC control signal for auto iris
control.
VIDEO: The mounted lens requires video signal
for auto iris control.
NOTE:
Refer to item-9 on page 6 for the tens selection
switch.
FOCUS OR FLANGE-BACK
ADJUSTMENT
The following adjustment should be made by qualified
service personnel or system installers.
1. Loosen screws on the flange-back adjusting ring.
Focus adjust for
C-mount iens
2. Turn the flange-back adjusting ring to the desired
position.
Caution:
Do not turn this ring too much to counterclockwise
as this could damage the inner glass and CCD
image sensor.
3. Tighten the screws on the flange-back adjusting
ring.
-17-