Installation (cont.), Antenna/cableconnections, Incoming cable from home antenna – Panasonic CT-13R17 User Manual
Page 6: Incoming cable from cable company, Other video equipment, Antenna/cable connections other video equipment, Installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
(cont.)
Antenna/CableConnections
Antenna Connection
- For proper reception of VHF/UHF channels, an external
antenna is required. For best reception an outdoor antenna is recommended.
Antenna Mode must be set to TV.
(Refer to Antenna Mode section.)
75 Ohm
Incoming Cable from Home Antenna
300 Ohm
Indoor
Typical VHF/UHF Antenna
VHF/UHF
on Back of Set
VHFAJHF
on Back of Set
or
300 to 75 ohm Matching Trans-
fonner (Supplied 13” Models Only)
Cable Connection
- For reception of cable channels, connect the cable supplied by your local cable company. Antenna
Mode must be set to CABLE.
(Referto Antenna Mode section.)
Incoming Cable from Cable Company
75 Ohm
VHF/UHF
on Back of Set
NOTE:
Certain cable systems offset some channels to reduce interference or have Premium (scrambled) channels. A
cable converter box is required for proper reception. Check with your local Cable company for compatibility
requirements.
Other Video Equipment
VCRs, Video Disc Players, Computers, TV games, and DSS equipment can also be connected to the antenna input
connection.
How to Install VHF/UHF Dipole Antenna (13” Models Only)
A VHF/UHF antenna and matching transformer are supplied.
Push the stem of the VHF/UHF antenna into the antenna hole on the cabinet back as shown.
Extend the antenna and adjust its length, direction and angle for the clearest picture.