Cleaning or replacing the fiuorescent lamp, Cleaning or replacing the ruorescent lamp – Panasonic Panafax UF-270 User Manual
Page 85
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cleaning or Replacing the Fiuorescent Lamp
If the receiving party reports that the received documents were black, or contained black lines, try
making a copy on your unit. If the copy is black or has black lines, the fluorescent lamp is probably
dirty or defective and must be cleaned or replaced.
WARNING:
H
The fluorescent lamp Is hot to the touch just after being turned off. Before replacing the lamp, wait 5 minutes or more
after turning the power switch OFF.
1. Turn the power OFF
(O).
Unplug the power cord. Remove the sub tray and handset. Stand the
machine up and remove the Bottom Board Unit screws.
2.
Open the Bottom Board Unit towards you. Slide fiuorescent unit forward. Clean the fluorescent
lamp surface with clean cloth. To replace, unplug the connector and pull up both sides of the
set guide a little so as to free the boss on the plates.
To reinstall, insert the both sides of set guide and plug in the connector. Return the fluorescent
lamp to its original position.
Close the Bottom Board Unit and replace the screws. Return the machine to its original position
and reset the sub tray and handset. Plug the power cord in, then turn the power ON ( I ) .
84