Option 1, Option 2, Cj® ©! r – Panasonic CT-20G21 User Manual
Page 10: Control operation, Helpfui hints
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Control Operation
POW6r Button
— Press the POWER button to turn
ON Press again to turn OFF
VOL
(Volume
Buttons)
—
Press
the
VOLUME (VOL) LEFT or RIGHT button for desired
listening level (when On Screen menus are not
displayed)
Located On Remote Control
Increases
Vclume Level
CH (Channel) Buttons
Option 1.
Press the CHANNEL (CH) UP or DOWN button to
sequentially scan through programmed channels
(when On Screen menus are not displayed)
NOTE' TV/CABLE switch (located on Remote) must be
set in TV position (Left)
Located On Remote Control
TV/C&BLE
n—I
Selects Next
LcwerChannel
S
b
I
bc
I
s
N
bm
I
Higher Channel
Mute Button
— Press the MUTE button to quickly
reduce sound level (Mute will appear on screen) Press
again to restore sound
MUTE
a
R-Tune (Rapid Tune) Button
— Press the
R-TUNE (RAPID TUNE) button to instantly switch
between the last two channels selected (without any On
Screen display being activated)
CHANNEL
NOW
BEING VIEWED
R-TUNE
ft
Press Buttnn
CHANNELTUNED
IMMEDIATELY BEFORE
Helpfui Hints:
■ Helpful information will display On Screen momen-
tanly when Receiver is first turned on and when the
channel
IS
changed
■ When using keyboard entry for channels 10,11 and
12 in the CABLE mode there is a slight delay before
channel change because of the capability of tuning
cable channels 100 to 125
NOTE. If no sound
IS
heard from the speakers, press
the TV Speaker button located on back of
Receiver
Keyboard “0 through 9” Buttons
Option 2.
Press two digits on the keyboard □ through 9 buttons
(Example press □, then 5 for channel 05) For
channels over 99, press three digits on keyboard
I© © @1
©cj® ©!
r~
VCR Function Buttons
- The VCR
FUNCTION buttons have been designed to operate
numerous brands of VCRs The infrared code must be
□blamed prior to use (Please refer to Programming the
Universal Remote for programming instructions )
NOTE: The TV/CABLE switch (located on Remote)
must be in the TV position (Left)
IVCH MUER
rec
]
SO
I REU STOP PLAY FF 1
r5~l HE]
PAUSE
I TV/VCH VCR CHANNEL
I O ® C
a
) O
- 10-