Precaution on battery use, Installation – Panasonic CT-20G21 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
Receiver Location
This unit IS intended to be used wilh an optional stand or enlertainment center Consult your dealer Гог available options
Locate Гог сотГогГаЫе viewing Avoid placing where sunlight or other bright light (including reflections) will Fall on the
screen
Use of some types оГ fluorescent lighting may reduce remote control transmitter range
Adequate ventilation is essential to prevent internal component failure Keep away from areas of excessive heat or
moisture
To insure optimum
color
purity do not position magnetic equipment (motors, fans, other speakers, etc ) nearby
Optional External Equipment Connections
The Video/Audio connections between components can be made with shielded video and audio cables For best perfor
mance, video cables should utilize 75 ohm coaxial shielded wire Cables are available from your dealer or electronic
supply house
Before you purchase any cables, be sure you know what type of output and input connectors your various components
require Also determine the length of cable you'll need
AC Power Supply Cord
CAUTION. TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT OF AC OUTLET AND FULLY INSERT DO NOT USE THIS (POLARIZED) PLUG
WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE
Remote Control Battery Installation
Battenes Use two "AA" batteries
1
Turn the Transmitter face down To remove top cover, press down on
marking and slide cover off in the direction indicated
2
Install the batteries as shown in the battery compartment (Polarity (+) or
(-) must be correct)
3
Replace the cover and slide in reverse until the lock snaps
4
For heavy Remote Control use, replace old batteries with Alkaline
batteries for longer life
Precaution on Battery Use
Incorrect installation can cause battery leakage and corrosion that will
damage the Remote Control Transmitter
Observe the Following Precautions:
1
Batteries must be replaced as a pair
2
Do not combine a used battery with a new one
3
Do not mix battery types (Example “Zinc Carbon" with “Alkaline”)
4
Do not attempt to charge, short-circuit, disassemble, heat or burn used
batteries
5
Battery replacement is necessary when Remote Control reacts
sporadically or stops operating the Receiver
-
5
-