Panasonic TC-25V50H EN - Manual (Page 23)

Remote Control Operation
NICAM Digital Stereo
(For TC-25V50H, TC-2552G)
The on-screen will display as follows :
1_._BeoiJiar broadcast (Standard Audio).
2. NICAM MONO I ( MAINCO^
Press the button to select ” MAINCID **
or ” MONO ” audio signal.
^— -------------------- ^
MAENC13
—
MONO
— __________ J Ч ____
aJ^tCAM SI^R^Q
Press the button to select ” STEREO ”
or ” MONO ” mode.
Л
STEREO
r
MONO
V __________ J V ------- __________ )
4. NICAM DUAL MONO i MAINCID / S U B C l l )
Press the button to select the" MA1NC13 ”
or” SUB СИЗ” or "MONO’*
(----------
MAINCID
____ ^
(
------------ ---------------------Ч
SUBCED
_________________ > _______
/------------------------------- ^
MONO
Note:
1. If the stereo signal is weak or the receiving
are poor, it is recomended to switch to
the" MONO" mode.
2. When the power is switched ON, the mode
is preset at either ” MAINCI3 or STEREO *’.
3. Even when the contents of the receiving
signal changes, selection mode is kept intact
4. When the receiving conditions deteriorate,
listening will be easier if the mode is set to
the ” MONO" position.
23