Panasonic PV C2032W - Manual (Page 23)

Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any fijture daily or weekly reairdings
will be performed as programmed.
SELECT/SET
^ :CH UP
▼ :CH DOWN
► :VOL UP
◄ ;VOL DOWN
PROG
ADD/DLT
STOP
Review, Replace or Clear Program
Contents : (Recording is not in progress)
^ Repeat steps 1 and 2 on page 22.
P DT START STOP CH SPD
2 8 10:CX)a12:OOp125 SP
3 10 B:00p 9:00p 10 SP
4 SU 9r00p10:00p L LP
CAMCEL;ADD/DLT
SELECT
I-8: A T
ENTER :►
END
;PROQ/AtmON
Press AT to select
thedesired program.
To Replace program...
1) Press ►to display.
2) Press AT to select
and press ^ or ►
to set new program
contents.
3) Press PROG {or
ACTION).
fsAjRl/ START STOP ~
ch
1
8 SAT 9:OOP12:OOA 08
T$1)AT\ ABC
SP
SELECT:A *
SET :4 ►
END :PROG/ACTlON
To Clear program...
p DT START STOP CH spd I Pfess ADD/DLT,
B 10:00p12:00a125
10 8:00p 9;00p 10
SU 9:00p10:D0p L
SELECT 1-8:A ▼
ENTER ,>
END :PH00/ACTI0N
Press PROG twice (or ACTION)
to exit this mode.
• 2 minutes before Timer recording is performed,
“PLEASE PREPARE FOR TIMER REC" appears and/
or the PROG TIMER Indicator flashes. Be sure a
cassette with record tab is loaded and the unit is in
Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up during
a normal recording or One Touch Recording (page 12),
the Timer Recording will not be performed.
• If there is a power interruption of more than one minute,
the recording may not be performed or continued.
• If “INCOMPLETE" appears after all items have been
set, check all entries and make necessary corrections.
23